Table of Contents
Advertisement
INSTALLATION
Install with the appropriate hardware to suit the mounting surface. Select a suitable location that
is protected from accidental damage or tampering, and environmental conditions that could
exceed the camera's general specifications. Ensure the selected location is protected from falling
objects, accidental contact with moving objects, and unintentional interference from personnel.
Follow all applicable building codes.
NOTE: Make sure the camera is correctly oriented when mounting – see picture below:
The "TOP" designation label on the housing indicates the correct upright viewing orientation for
the camera lens.
The weight of the camera is 2.27 KG (5 lbs). It is recommended that all hardware used for
mounting be capable of supporting four times the actual weight of the unit (ie: 10 KG or 20 lbs).
The camera must be bolted to the mounting surface using the 5/16" mounting lugs as shown in
the picture above. Rubber washers should be installed on the housing side of the bolts to avoid
damage to the epoxy housing finish. Fluorosilicone or Aramid/Buna-N type washers are
recommended for maximum oil, abrasion, chemical and weather resistance
CAUTION! Do not remove the housing cover when mounting the camera to prevent
damage to the camera module and interior components. The housing cover should only
be removed after mounting to allow for the focusing of the lens to the desired focal
length. See details of lens focusing below.
Opticom Technologies Inc.
www.opticomtech.com
www.toughestvideocamera.com
March 2016
CC03-IP2MVFIR Camera
TOP (2 x 5/16" Mounting Lugs)
BOTTOM (2 x ¾" NPT Openings)
USA Sales:
Battle Creek, Michigan:
Canada:
Head Office (Vancouver):
Installation Manual
800-578-1853
855-569-3240
Advertisement
Table of Contents
