Regency LWD6524 Instructions

You will need a Phillips Head screwdriver and a rubber mallet to assemble.

Hardware :

A: Locking shelf pins(4) • B: Pole Support(2) • C: Hinges(3) • D: Brackets(3) • E: Shelf Pins(4)
F: Long Screws(2) • G: Cam pins(19) • H: Adjustable Glides(4) • I: Cam lock covers(19)
J: Hole Covers(3) • K: Small Screws(34) • L: Handle • M: Pole • N: Door stopper(2) • O: feet(4)
A B C

Parts :

P: Front Runner • Q: Adjustable shelf • R: Fixed shelf • S: Door • T: Top • U: Left side • V: Right Side
W: Back • X: Bottom Y: Support Shelf
Q
P
STEP 1 : Lay Back(W) down with cam locks facing
up and screw in one cam pin(G). Connect bottom(X)
to back(W) by inserting the cam pin on the back into
the lock on the bottom and Tighten
the cam locks on the bottom are facing away from
the back.
W
G

IMPORTANT NOTICE:

● Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid the parts from being scratched.
● Check to be sure that you have all parts and hardware.
● Remove all wrapping materials, including staples & packing straps before you start to assemble.
● Do not tighten all screws/bolts until completely assembled.
● Keep all hardware parts out of reach of children.
LWD6524- INSTRUCTIONS
D E F G
S
R
Be sure
(See Fig 1).
W
X
Any problems or questions call Regency Office Furniture at 1-866-816-9822
H I J K L M N
T U
STEP 2 : Attach 3 brackets(D) with 2 screws(K)
each to the right side(V) and 7 cam pins(G) to each
side(U&V).
G
G
G
G
G
O
V W X
D
V
D
G
G
D
G
G
Y
Fig 1
G
U
G
G
G
G