Table of Contents
Advertisement
Can Holder Assembly Removal And Cleaning (Optional)
Remove plastic can clamp by screwing knob off the threaded shaft. Wash the can holder and can clamp with a non-
abrasive detergent to maintain sanitary gloss. Remove the shaft by loosening the wing nut and unscrewing the shaft
from the shelf. Wash the shaft and shelf using a non-metallic brush.
Frost Shield Removal and Cleaning (optional)
When the frost-shields accumulate approximately ½ to 1 inch of frost (about two to three days), remove it by lifting
up to disengage from the keyhole slot. Remove the frost by holding under running water until clean. Dry and replace
the frost-shield by engaging screws at the big end of the keyhole and push down.
11
5/21 Rev. E 143568
Advertisement
Table of Contents
