Advertisement
Installation
Installation
Note: Audiobahn strongly recommends that you operate your system at low volumes prior to the completed
installation of your Audiobahn speakers. This will allow a test of the speaker before securing it to its permanent
location.
Caution: Make sure that all speaker wiring is fully protected from cuts, tears and possible wear. All short circuits
developing as a result could severely damage the source unit or possibly the amplifier as well as the speakers
themselves. Makes sure all speaker wires are placed easily within reach of the speaker terminal with no stress
on the wire or connectors.
Mounting
1) Confirm the mounting location and depth requirements by inspecting the area where the speaker will be
mounted. Most speakers will fit into stock locations on the vehicle. In this case only depth consideration is
important.
2) If the location you have picked does require cutting, you may use the supplied template to help you locate
and mark the mounting location and cuts to be made. Be careful when cutting out the template. If you cut the
template properly, the speaker will be a perfect fit.
3) If there is a cosmetic panel where the speaker will be mounted, we recommend using a utility knife to
carefully cut a hole in it. Confirm the cut by placing the speaker in the hole. You may need to modify the hole cut
as necessary.
4) If it is necessary to cut steel, reinstall the cosmetic panel in place and use the hole you have previously cut
as a template. This will help to insure proper cutting and a good fit. Mark the locations for the speaker mounting
screws. Then remove the panel and drill the screw holes. When finished you can replace the panel.
5) After cutting and drilling all holes, inspect the mounting areas for any metal burrs or rough edges. File any
area that may interfere with the mounting of the speaker.
6) Clean any metal shavings from the mounting area and check for areas in which water may enter the speaker
cavity. Treat the area for water protection when necessary.
Make sure your source unit (Cassette, CD, DAT, DVD etc.) is turned off while connecting the speaker terminals.
Turn on the various components and slowly advance the volume. Remember to check and recheck all
connections to insure you have a secure fitting.
7
Advertisement
