Table of Contents
Advertisement
Installation
7
Angled Surface Mount
This will allow you to mount your tweeter on the surface and give you
the ability to have the tweeter facing in almost any direction that you desire.
1. You will need to remove the center part of the double sided sticky tape
2. Remove one side of the protective backing of the tape and place it on
3. Locate the proper position that you would like to mount the
ONLY FOR AT60J
Surface Mount
4. Drill a 3/8" hole for the wire if needed
5. It is recommended to use the two supplied screws to mount the angle
This will allow you to mount your tweeter on the surface and allow you not
to have to cut a large hole in your vehicle
1. You will need to remove the center part of the double sided sticky tape
2. Remove one side of the protective backing of the tape and place it on
3. Locate the proper position that you would like to mount the tweeter,
Flush Mount
4. Drill a 3/8" hole for the wire if needed
5. It is recommended to use the two supplied screws to mount the angle
This will allow you to mount your tweeter flush with the panel and have the
tweeter look like it came from the dealer.
1. First find a location that you would like to mount the tweeter
2. Draw a small dot on the location of each tweeter and make sure that
3. Remove panel and double check that there is enough room behind the
4. Drill a 1 1/2" hole for the supplied flush mount cup
5. insert the flush mount cup and make sure that it fits in to the hole that
6. Use the supplied pressure ring behind the penal to finalized the
7. Make sure when you insert the tweeter into the flush mount cup that
the back of the angled mounting piece
tweeter,then remove the protective backing on the sticky tape and
place the tweeter where needed
piece down due to the vibrations from the vehicle
the back of the angled mounting piece
then remove the protective backing on the sticky tape and place the
tweeter where needed
piece down due to the vibrations from the vehicle
both tweeters are mounted equally
panel for the tweeter (At least 1" depth and 1 1/2" diameter)
you just have drilled
mounting of the flush mount cup
you first put the "angled surface mount cup" on the tweeter. This will
allow you to create a 360 degree swivel mount on the tweeter
Advertisement
Table of Contents
