Steam Ironing; Shot Of Steam; Dry Ironing; Vertical Steaming - Russell Hobbs Easy store Instructions Manual

h STEAM IRONING
27 If you intend to use steam, the temperature setting must be S or higher.
28 If you don't, you'll get water on your clothes, not steam.
29 Set the steam control to the setting you want (S = no steam, # = high).
30 Wait till the light goes off, then start ironing.
k SPRAY
, Water spotting affects some fabrics. Test this on a hidden part of the fabric.
31 This function works with dry or steam ironing, as long as there is water in the reservoir.
32 Lift the iron off the fabric.
33 Aim the spray nozzle at the fabric.
34 Press the * button.
35 You may have to press it 2 or 3 times to pump water through the system.
j SHOT OF STEAM
36 This function works with dry or steam ironing, as long as there is water in the reservoir.
37 If you intend to use steam, the temperature setting must be S or higher.
38 Lift the iron off the fabric.
39 Press the # button.
40 You may have to press it 2 or 3 times to pump water through the system.
41 Leave 4 seconds between shots, to let the steam build up.
n DRY IRONING
, If you're going to be dry ironing for 20 minutes or more, empty the reservoir first, to avoid
spontaneous bursts of steam.
42 Set the steam control to S.
43 Wait till the light goes off, then start ironing.
l VERTICAL STEAMING
44 Remove wrinkles from hanging clothes, hanging curtains, and furnishing fabrics.
45 Check that there is adequate ventilation behind the fabric, otherwise moisture may build up,
causing mildew.
46 Check that there is nothing behind the fabric that may be damaged by the steam.
47 Check that pockets, turn-ups, and cuffs are empty.
48 Check that there is water in the reservoir.
49 Set the temperature control to max. Set the steam control to S.
50 Lift the iron off the fabric.
51 Press the # button.
52 You may have to press it 2 or 3 times to pump water through the system.
53 Leave 4 seconds between shots, to let the steam build up.
C AFTER USE
54 Set the temperature control to •. Set the steam control to S.
55 Unplug the appliance.
56 Pull the funnel from the rear of the iron and push it into the water inlet.
57 Hold it over a sink, turn it upside down, and drain the water from the reservoir, via the water
inlet.
58 Wipe up any spillage.
59 Pull the funnel out of the water inlet, and push it into the rear of the iron.
60 Sit the iron on its heel.
61 Leave it to cool down completely.
62 When it's cold, wipe off any moisture, and wind the cable round the heel.
4