How To Engage And Disengage Seastation - Dometic SeaStation Installation And User Manual

3-2
The modes function as follows:
1. POSITION MODE
• This mode automatically controls the vessel's position and lets
heading drift freely.
• The P button engages/disengages POSITION MODE.
• A flashing LED means engagement needs to be confirmed on
the display.
• A solid LED means POSITION MODE is engaged.
2. HEADING MODE
• This mode automatically controls the vessel's heading and lets
position drift freely.
• The H button engages/disengages HEADING MODE
• A flashing LED means engagement needs to be confirmed on
the display.
• A solid LED means HEADING MODE is engaged.
3. POSITION and HEADING MODE
• POSITION and HEADING modes can be combined for complete
vessel control.
• The individual modes can be engaged separately or at the
same time.
3.2.2

How to engage and disengage SeaStation

DANGER!
Engaging SeaStation causes propellers to turn automatically. This could
injure someone in the water. It is the operator's responsibility to make sure
no one is in the water or enters the water. If someone enters the water,
pull all engine lanyard(s).
NOTICE!
SeaStation requires a GPS fix. In some conditions, this may require a few
minutes after power on.
Follow these steps to engage SeaStation:
1. The joystick must be in command of the vessel.
2. Press button(s) corresponding to desired mode(s) – see section 3.2.1.
3. A warning will pop up on the display alerting you to the possible
hazards of SeaStation.
4. The LED(s) of selected mode(s) will be flashing.
5. Press Engage on display to confirm the warning and engage the
selected mode(s).
6. The LED(s) of the selected mode(s) will be solid.
EN