Table of Contents
Advertisement
2-8
3. Secure the mount to the installation surface. Tighten to a maximum
torque of 10 lbs-ft.
4. Secure the surface mount adapter to the SeaStation sensor using the
supplied hardware. Tighten to a torque of 8–10 lbs-ft with no more
than 0.5 in thread depth engagement.
Figure 2-8: Surface mount adapter installation.
5. Thread the cable through the mounted baseplate and connect the
communication cable to the sensor.
6. Carefully secure the SeaStation sensor by placing it into the baseplate
until the four latches snap in place, first on one side then the other.
WARNING!
When installing the sensor, hand tighten only. Damage resulting from
over-tightening is not covered by the warranty.
EN
Advertisement
Table of Contents
