Settings - Dometic SeaStation Installation And User Manual

Name
Shift out of gear RPM
Shift Into of gear RPM
Position error for warning
Heading Error For Warning
Table 2-2.
2-14
STEP 3
1. Bring the boat to a stop with boost mode off.
2. Navigate to Dealer Menu > Initial Setup > Joystick > Balance
Sideways Power.
3. Select Off-Idle REV/FWD Ratio.
Figure 2-15.
4. Move the joystick sideways to port only enough to engage gears.
a. If the boat moves aft, press – to decrease the ratio. If it moves
forward, press + to increase the ratio.
b. Press Save.
c. Repeat until the boat rotates on the spot with no fore/aft movement.
The final value should lie between 100% and the Normal Rev/FWD
Ratio value.

Settings

2.7.2
There are several SeaStation parameters and they are not intended to be
changed in a typical installation – they are available for special cases.
All parameters are accessible through the CANtrak at Dealer Menu >
Devices > Main Joystick > Configuration > SeaStation > General
Settings.
If there are multiple joysticks, parameters must be changed in each of them.
SeaStation Parameters
Function
SeaStation will not shift out of gear if engine RPM is above this value
SeaStation will not shift into gear if engine RPM is above this value
SeaStation will sound an alarm if target position and actual position
differ by this value
SeaStation will sound an alarm if target heading and actual heading
differ by this value
Default Value
900 RPM
900 RPM
12 meters
45°
EN