Table of Contents
Advertisement
EN
4. Rotate the joystick clockwise only enough to engage gears.
a. If the boat moves aft while rotating, press – to decrease the ratio.
If it moves forward, press + to increase the ratio.
b. Press Save.
c. Repeat until the boat rotates on the spot with no fore/aft movement.
The final value should lie between 100% and the Normal Rev/FWD
Ratio value.
STEP 2
1. Bring the boat to a stop with boost mode off.
2. Navigate to Dealer Menu > Initial Setup > Joystick > Sideways
Rudder Angle..
3. Select Off-Idle Rudder Angle.
Figure 2-14.
4. Move the joystick sideways to port only enough to engage gears.
a. If the boat rotates clockwise as it starts to move, press – to
decrease the angle. If it rotates counterclockwise, press + to
increase the angle.
NOTE
The boat will rotate counterclockwise as it gains speed. This is normal
- our objective is to remove rotation during initial movement.
b. Press Save.
c. Repeat until the boats initial movement is directly sideways.
2-13
Advertisement
Table of Contents
