Polygroup SFX600 Owner's Manual page 9

Before assembly, take a few minutes to identify and become familiar with all the parts.
WARNING:
CLIMBING HAZARD! PLEASE PREVENT CHILDREN FROM CLIMBING ON THE FILTER CANISTER TO GAIN ACCESS TO THE POOL.
Skimmer Installation
1. Set up your pool following the pool Owner's Manual instructions. Do NOT fill
water until the Filter Pump is properly installed. Locate the Skimmer Opening
on the pool wall.
Skimmer Opening
Pool Inlet
3. Turn counterclockwise to remove the Skimmer Seal Ring
the Skimmer Gasket Rubber Seal
Return Fitting Installation
5. Assemble the Return Fitting
o
Inside Pool Wall
SETUP INSTRUCTIONS
. Make sure
d
is in the correct position.
h
The protruding edge of the
Skimmer Canister
9
in-between the two keys of
the Gasket .
h
No gap here
as indicated below.
Make sure the Hose Clamps
tightly over both the Return Hose
and O-Rings
2. Slide open the Top Cover
4. Insert the threaded part of the Skimmer Canister
Opening, and then secure with the Skimmer Seal Ring
fits
Inside Pool Wall
6. Now the Pump should be installed outside the pool wall as below.
seals
w
e
.
q
To optimize water circulation,
twist the RF Diverter
that it faces up and away
from the Skimmer Opening.
OWNER'S MANUAL
and take out the parts inside.
5
through the Skimmer
9
Make sure that the pool liner is
placed tight on the Gasket
and is NOT trapped in the threads;
otherwise leaks may occur.
Outside Pool Wall
Inside Pool Wall
so
p
5
.
d
h
thread slots
9