Volkswagen Passat 1995 Official Factory Repair Manual page 22

Engine, removing and installing
http://ebahn.bentleypublishers.com/vw/servlet/Display?action=Goto&type=repair&id=VW...
Rubber bushings for engine mount,
replacing
- Install engine holding fixture 10-222A with
supports 10-222A/1.
- Connect engine sling in hook eye on cylinde
head (left side) and tighten to lift engine sligh
- Remove engine mount.
- Pry spacer -2- from rubber mount bushing.
- Remove rubber mount bushings -1-.
Take notice of rubber mount bushing -1-
installation position.
- Install new rubber mount bushings.
- Press engine mount spacer into rubber moun
bushings.
- Install engine mount -4- and tighten bolts -3-
Tightening torque: 80 Nm (59 ft lb)
Page 15 of 16
10-13
5/12/2004