Related Manuals for Chicco Lullaby Primo
Summary of Contents for Chicco Lullaby Primo
- Page 1 Read all instructions BEFORE assembly and USE of product. KEEP INSTRUCTIONS FOR FUTURE USE. Lullaby Primo ® 3-in-1: Bassinet, Playard, Changing Table Owner's Manual ©2020 Artsana USA, INC. 03/20 IS0193E_01...
- Page 2 • The bassinet is designed for use ONLY are raised and locked in position child’s neck (hood strings, pacifier • ALWAYS PROVIDE THE with this Chicco Lullaby Primo Playard. whenever child is in product. cords, etc.) or attach strings to toys. SUPERVISION NECESSARY FOR •...
-
Page 3: Parts List
Parts List Parts List A. - Lullaby Primo Frame E. - Changing Table Frame Ends F. - Changing Table Frame Sides B. - Mattress Pad G. - Toy Mobile and Canopy C. - Bassinet D. - Changing Pad... - Page 4 Make sure top rails and center floor hub are locked and secure before use. This product requires adult assembly. Keep fingers clear of top corners during setup. 1. Remove Lullaby Primo Frame from the Carry Bag. J. - Parent Organizer...
- Page 5 Setting Up the Playard Setting Up the Playard 2. With the Lullaby Primo Frame 3. The center floor hub must be pulled standing upright, pull the corners up to allow the top rails to lock. apart as shown. With the center hub even (or level) If needed, pull up on the center floor with the 4 corners.
- Page 6 Setting Up the Playard Setting Up the Playard 4. Push down on the center floor hub 5. Install Mattress Pad, padded side until the bottom of the playard is flat. up. Do not use playard without Mattress Pad and make sure to fold hook and loop strap underneath Mattress Pad.
- Page 7 Setting Up the Playard Setting Up the Playard 6. Locate 4 Mattress Pad strap holes 7. Turn the playard on its side and pull on the floor of the playard. Thread the straps through the floor of the the 4 hook and loop straps through to playard.
- Page 8 Setting Up the Bassinet Setting Up the Bassinet 8. Undo the hook and loop straps 9A. Unfold the Bassinet sides as from the frame and remove Mattress shown. Pad from playard.
- Page 9 Setting Up the Bassinet Setting Up the Bassinet WARNING 9B. Unfold the Bassinet ends over the playard frame. Fit the 4 corners Do not place Bassinet on unit if a child is in the playard. Make sure playard is of the Bassinet over the 4 corner fully assembled.
- Page 10 Attaching Parent Organizer Changing Table Warnings WARNING 11. Attach the Parent Organizer to the side top rail of the playard as shown. FALL HAZARD : Children have suffered serious injuries after falling from Parent organizer can be attached to changing tables. Falls can happen quickly. either side.
- Page 11 Assembling Changing Table Assembling Changing Table 13A. Insert the Changing Table Frame Sides into the openings on the back of the Changing Pad and slide up. “CLICK!” 12. Slide the end of the Changing Table Frame Side into the groove of the Changing Table Frame End until it clicks into place.
- Page 12 Assembling Changing Table Assembling Changing Table 15. Flip the Changing Table right side 14. Locate the fabric tabs along the up. Arrange the Zipper insert so that outside of the Changing Pad. Thread all 4 of the hook and loop tabs are the fabric tabs through the lined up and connected.
- Page 13 Assembling Changing Table Assembling Changing Table 16. IMPORTANT: The Changing Table 17. Remove the Changing Table by can only be attached to one end of pushing in on the release buttons and the playard. Locate the changing lifting up. table receptacles on the side of the playard.
- Page 14 Mobile Assembly and Use Operate Mobile WARNING Before attempting to operate the Mobile Arm and Mobile Light, Do not mix old and new batteries. Do not mix alkaline, standard (carbon-zinc), install 3 "AA" batteries in both units. or rechargeable (nickel-cadmium) batteries. Remove batteries before storing this product.
- Page 15 Operate Mobile Operate Mobile 19. Insert the 3 canopy support 20. Press in on the center of the sections into the fabric sleeve, as canopy support to flip it into the fabric shown. sleeve.
- Page 16 Assembling Toy Mobile Assembling Toy Mobile 21. Insert the knot at the end of the 22. Slide the Toy strap through the Toy Mobile canopy string through the opening on one of the sides of the Toy opening at the top of the Toy Mobile Mobile.
- Page 17 Assembling Mobile Assembling Mobile 23. Attach the Mobile by sliding the 24. The curve of the Mobile Toy bar base down over any of the playard can be adjusted as shown. To remove corners with the Bassinet attached. the Mobile base pull out to release Line up the post with corresponding the bottom edge of the Mobile base Bassinet corner slot and push down...
- Page 18 Packing Up the Playard Operate Mobile 26. Remove the Bassinet, Toy Mobile, Parent Organizer, Changing Table and Mattress Pad. Pull up on the center floor hub release strap and lift the center hub up as far as possible. 25. Slide the switch to the left to turn the mobile "ON". Slide the switch to the right to turn "OFF"...
- Page 19 Packing Up the Playard Packing Up the Playard 27. Lift and squeeze the Top Rails 28. Pull up on the center floor hub center release lock, then push down. release strap and pull the playard legs Release all of the Top Rail locks on all towards the center.
- Page 20 Packing Up the Playard Packing Up the Playard 29. Place the Mattress Pad into the 30. Pull up the sides of the Carry Bag Carry Bag - Make sure the padded and close the zipper. side of the mattress pad is facing up. Then place the folded playard into the Mattress Pad.
- Page 21 Packing Up the Playard Fitting and/or Replacing Batteries WARNING 31. To keep instructions for future use: Place the manual in the storage The Electronic Play Tray requires 3 x “AA” 1.5 Volt alkaline type batteries (not sleeve located on the underside of the included).
-
Page 22: Troubleshooting Guide
Periodically check the playard for loose screws, worn parts, torn material or stitching. Replace or repair the parts as needed. Use only Chicco replacement parts. Keep the playard in a dry place. If playard becomes wet open playard and allow to dry completely. -
Page 23: Fcc Information
For More Information FCC Information If you have any questions or comments about this product, or are missing any of Warning: Changes or modifications not expressly approved by the party the parts please do not return this product to the store. Contact us in one of the responsible for compliance could void the user’s authority to operate the following ways: equipment. - Page 24 www.chiccousa.com...