Siemens SIMATIC S5 Series Manual page 53

File Transfer
Additional
Parameters
6
6-8
If the link is established successfully, FTARC displays the status
"connected" at both devices and determines, for both the local and
remote partner, the type of device, the ARCNET node number set,
the operating system and the path (user area under PCP/M) under
which FTARC was started. This information is displayed in the
lower part of the main menu.
If the status "connected" is not displayed, although FTARC is
started on both devices, or if an error message appears at the start,
check the installation.
When you start FTARC you can also specify additional parameters
(from FTARC V 1.4):
ftarc [-tim=<sec>] [-v]
-tim=<sec> watchdog time interval in seconds (standard = 30 secs).
The parameter must be entered identically at both devices.
-v verify function on (form checksum). Checksum is formed
for source and destination. If the comparison is negative,
the error information is reported to an error file. The
parameter must be entered identically at both devices.
-? display help text
-h
display help text
Notes on operation:
Functions are started by pressing the function keys indicated.
In fields where you can type in an entry, the DEL key can be
used for correction purposes.
To jump between fields, use the TAB key and cursor control
keys.
Working with S5-DOS/ST
C79000-G8576-C760-03