Pentair Fleck 2910 NXT User Manual page 6

User Guide Fleck 2910-NXT
3.3. Components description and location
Status LED
Diagnostic button
3.4. Bypassing
If the system is equipped with a bypass and if a problem occurs, turn the valves to bypass the system as shown in the picture
below.
Normal
operation
Out
4 . Programming
Note:
The controller must be plugged in to be programmed.
After 5 minutes with no button pressed, the unit returns to normal operation without saving.
4.1. Basic programming
Note:
Menus are displayed in a defined and incremental order.
Choice of language
A
Press and
B
Select the language to be displayed with
C
Press to validate the selection and advance to the next parameter.
Feed water hardness
Note:
This parameter is not visible in Timeclock mode, and allows to adjust the water hardness in °tH.
D
Adjust the hardness with
E
Press to validate the selection and advance to the next parameter.
Calendar override
Note:
Determine the maximum number of days of operation without regeneration.
F
Adjust the number of days with
G
Press to validate the selection and advance to the next parameter.
6 / 36
LCD display
Shift button
UP/DOWN button
Regen button
Meter
ON/OFF Line Indicator
Softening
System
simultaneously for 5 seconds to enter the menus sequence.
and .
and
Meter connection
Outlet
In Bypass
In
and .
.
Injector
Drain
Softening
System
Out
SELECT LANGUAGE:
WATER HARDNESS
DEGREE
CALENDAR
OVERRIDE 03 DAYS
Ref. MKT-UG-002 / B - 26.06.2018
Inlet
In
ENGLISH
0030fTH