MSI 790GX-G65 Series User Manual page 43

M S-7576 M ainboard
DRAM Drive Strength
This feature allows you to control the memory data bus' signal strength. Increasing
the drive strength of the memory bus can increase stability during overclocking.
DRAM Controller Selection
This feature allows you to select the DRAM controller.
1T/2T M emory Timing
This item controls the SDRAM command rate. Select [1T] makes SDRAM signal
controller to run at 1T (T=clock cycles) rate. Selecting [2T] makes SDRAM signal
controller run at 2T rate.
DCT Unganged Mode
This feature is used to Integrate two 64-bit DCTs into a 128-bit interface.
Bank Interleaving
Bank Interleaving is an important parameter for improving overclocking capability
of memory. It allows system to access multiple banks simultaneously.
Power Down Enable
This is a memory power-saving technology. W hen the system does not access
memory over a period of time, it will automatically reduce the memory power
supply.
MemClk Tristate C3/ATLVID
This setting allows you to enable/disable the MemClk Tristating during C3 and
ATLVID.
FSB/DRAM Ratio
This item allows you to select the FSB/DRAM ratio.
Adjusted DRAM Frequency (MHz)
It shows the adjusted Memory frequency. Read-only.
Onboard VGA Over Clock
This item allows you to overclock the onboard VGA.
Onboard VGA Clock
This item will appear when Onboard VGA Over Clock sets to [Enabled]. It allows
you to adjust the onboard VGA clock.
HT Link Control
Press <Enter> to enter the sub-menu and the following screen appears.
En-34