MSI 790GX-G65 Series User Manual page 24

Fan Power Connectors: CPUFAN1, SYSFAN1~3
The fan power connectors support system cooling fan with +12V. W hen connecting
the wire to the connectors, always note that the red wire is the positive and should
be connected to the +12V; the black wire is Ground and should be connected to GND.
If the mainboard has a System Hardware Monitor chipset on-board, you must use a
specially designed fan with speed sensor to take advantage of the CPU fan control.
GND
+12V
SENSOR
Control
CPUFAN1
Important
1. Please refer to the recommended CPU fans at processor's official website
or consult the vendors for proper CPU cooling fan.
2. CPUFAN1 supports fan control. You can install Overclocking Center
utility that will automatically control the these fan speed according to the
actual CPU and system temperature.
3. Fan/heatsink with 3 or 4 pins are both available for CPUFAN1.
4. SYSFAN1/2 support fan control, too. You may
for the SYSFAN1/2 in BIOS.
Chassis Intrusion Connector: JCI1
This connector connects to the chassis intrusion switch cable. If the chassis is
opened, the chassis intrusion mechanism will be activated. The system will record
this status and show a warning message on the screen. To clear the warning, you
must enter the BIOS utility and clear the record.
SYSFAN1/2
select the percentage of speed
1 CINTRU
2
GND
JCI1
NC
+12V
GND
SYSFAN3
En-15