Advertisement
The tyre is mounted over the flat end of the tyre tool. Place
the ball head piece under pressure on the lower side of the
tire (always facing the driver) between the rim and the bead.
With the flat side against the centre post, you turn the tool full
circle for cabin lower and upper edges.
Bleed the tire and place the wheel on the fixing rod at the
main stand base. Position the bead protector in the bead area
and adjust the pivot bar on the main stand leg to the correct
height.
Insert the demountable bar into the shoe and pull it down to
break the bead. If necessary, turn the tire 90° and repeat the
procedure. To break the bead on the other side, turn the
wheel over and repeat this step.
Caution!
It is important that a high quality tyre lubricant is used during assembly and disassembly.
Make sure the bead is centred on the rim during the process. In the unlikely event that you will have
trouble turning the handle, use a tyre lever. Use a tyre iron to loosen the tire around the point of
greatest resistance.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Important:
Always lubricate the tyre!
Item 61909
Page 8
02
2021-1
Advertisement
