Advertisement
7. Position the jaw frame on the main stand base and tighten it
with the supplied 12 mm cheese head screws and nuts. You can
now use the device.
General information
This tyre changer is suitable for all wheel sizes between 101.6 mm (4") and 434 mm (17"). The
tyre is held in place by two adjustable jaw clamps with holes and an adjustable slide jaw
clamp. Two centre posts (four shaft sizes) are provided either for the centre of the bearing or
for the centre of the hub.
When servicing bearing-centred wheels, use a centre shaft corresponding to the bearing size
of the wheel (½",
wheel bearing.
Maintenance of hub-centred wheels uses a large diameter post. Insert the post directly into
the middle of the arms as soon as the wheel is in place.
Operation instructions
Slide clamps are positioned to the correct wheel size as indic-
ated by numeric markings on each arm. The pins are inserted
on the outside of the terminals. Press the two clamps against
the pins.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
5
/
" or ¾"). Once the wheel is in place, insert the appropriate post into the
8
Item 61909
Page 6
02
2021-1
Advertisement
