Advertisement
The slide clamps must be set to a position that is larger than
the tyre to be machined with the rotating crank arm.
The wheel is positioned. The wheel rim is pressed against the
two slide clamps. Insert the centre post into the centre of the
wheel and into the centre hole of the tyre changer. Tighten the
adjustable brackets to secure the wheel.
Dismount the vented tyre using the rod end of the tyre tool.
The ball end is pushed under the upper bead and placed on
the rim (see illustration). While pushing the lever toward the
centre with one hand, the tire must be raised with the other
while rotating the unit in a circle.
Disassemble the lower bead in the same way as above. The
angle of the tool to the centre post can be varied according to
operator height or rim depth, without compromising ease of
operation.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Item 61909
Page 7
02
2021-1
Advertisement
