Table of Contents
Advertisement
LABEL EDITOR - Pushing the LABEL button in this menu allow for a
customized labeling of the PRESET through the alphanumeric keypad.
Enter the desired preset name and press the OK button. This can be done
for each PRESET as required.
DIM - This button allows you to quickly select the entire PRESET to
operate as a Dimmer or a Non-Dim. If set as Non-Dim, a vertical bar on the
right side of PRESET is visible and this PRESET becomes a toggle switch.
FADE TIME - This allow each PRESET to have a customizes fade time.
Maximum FADE TIME is 1 hour.
2. PROGRAM A PRESET FROM THE PWS - This method of PRESET
recoding can be done at any MAIN PWS without a DMX source. An ADMIN
level PASSWORD is required. Steps 1-5 in the SET UP and Configuration
of the manual must be done prior to PRESET Recording.
•
Select the PRESET you wish to program by pushing and holding that
particular PRESET.
•
A pop-up menu similar to the one shown below will display. Eg.
PRESET 22.
NOTE:
The virtual Master Slider is the only item that a user can access
and will permit user EDIT of the previously recorded PRESET ± 50%.
Escaping out of this PRESET will not overwrite previously recorded levels.
WWW.JOHNSONSYSTEMS.COM
27
Advertisement
Table of Contents
