Table of Contents
Advertisement
1. PASSWORD / SECURITY LOCK
Each PWS requires a valid Password entry to access certain functions.
Access via the Security Lock icon, the lock will display red when locked and
green when unlocked. Each PWS will default to a "locked" state with access
to only select functions for protection of programing and restriction of use. A
small red lock will appear in the upper left of the display when in the locked
state. Only preset playback and minor edits of preset levels are permitted in the
secure "locked" state.
Each PWS has two passwords to permit controlled access to specific menu
functions:
USER: Factory default "12345" - allows limited access to screens.
ADMIN: Factory default "98765" - allows full access to all screens.
Passwords must always be a 5 digit number. The password is stored in
the removable external EEPROM plug in module on the rear of the PWS.
Passwords are entered at the room Main PWS only and then shared with the
room Secondary PWS via the SYNC command.
Important!
On SYNC Main/Secondary, all Secondary PWS will have the same
password as the room/zone Main PWS. The user will not be able to change
the password on a Secondary either manually or with the DIPSW. This function
and option is reversed to the Main Station for the room only.
Password privileges for the PWS are shown below:
Screen
MainScreen
PSEnableScreen
InfoScreen
DateTimeScreen
DMXSetupScreen
ScheduleScreen
AUXScreen
SyncScreen
BLEScreen
PresetEditScreen
The PASSWORD entry screen is shown at right:
Enter the PASSWORD and press [OK]. If the PASSWORD is correct, the
PASSWORD screen will close and take you back to the main screen.
The screens will lock again if:
a) PWS goes to sleep (no keys for 5 minutes).
b) Enter the PASSWORD screen and press [c] and exit without pressing OK.
c) For the PRESET Edit screen, upon exiting the PRESET Edit mode (USER only).
If the PASSWORD is incorrect, the screen will show (at right):
Password Level
ADMIN
ADMIN
ADMIN
USER
ADMIN
ADMIN
ADMIN
ADMIN
ADMIN
*ADMIN / USER
WWW.JOHNSONSYSTEMS.COM
Info Screen
1.
Room Number
2.
Model Number
3.
Firmware Version
4.
Serial Number
5.
System Voltage
Important!
Do not access FACTORY
DEFAULT unless intentional.
An ADMIN could accidently overwrite
all programmed data.
17
Advertisement
Table of Contents
