Controls And Indicators - Audio Pro STEREO TWO Operating Instructions Manual

cONTROLS aNd iNdicaTORS

HEad UNiT
Front panel
18
1) Power switch
Press this button to turn on the receiver, provided it
is in standby mode (indicated by the red LED on the
ace-bass indicator (# on the diagram). If it is not illu-
minated, then the receiver is turned off, in which case,
turn on the ON/OFF switch at the back of the unit (ON).
The power switch is also used to place the receiver in
standby mode. NOTE! The ON/OFF switch at the back
of the unit turns it off completely. In standby mode, the
unit can be turned on and off with the remote control.
The latter procedure will not work if the ON/OFF switch
on the back of the unit is turned off. (OFF)
2) Operating mode indicator
Indicates whether the unit is turned on (blue) or in
standby mode (red). If it is not illuminated, the receiver
has been turned off with the ON/OFF switch on the
back panel.
3) Source (selection of audio source)
Turn this dial to select the audio source (CD/Radio/AUX
or Line-in) on the front of the receiver. The source will
be indicated briefly on the display (7).
4) FM/aM
Press this button to select FM/stereo, FM/mono
or AM.
5) display
Press this button to change the operation indicator
on the display (7), for example, time, audio source, or
choice of RDS modes in the radio position.
See page 4.
6
17
1 2 3
15
16 14 13
4 5 6 7
6) Menu
Press to set the TIME and TIMER modes. See pages
 and 7.
7) display
Operation indicators are displayed here.
8) Window for remote control reception
To use the remote control, aim it at this window.
9) Phones (jack for headphones)
Connect the headphones cable with a .5 mm [/8
inch] plug. Once the headphones are plugged in, the
output for the speakers turns off automatically. Adjust
the volume level. NOTE! Turn down the volume before
connecting the headphones.
10) Line in
An additional audio source, for example, an Mp or a
portable CD player, can be connected here with a .5
mm [/8 inch] stereo plug. Select LINE as the audio
source with the SOURCE button ().
11) volume
Use this knob to adjust the volume. There are ca. two
full turns from minimum to maximum volume. As the
knob is turned, the volume level is shown on the dis-
play. VOL OO indicates minimum volume (quiet) and
VOL MAX indicates maximum volume.
12) Eject
Press this button to open or close the CD tray.
12
8 9 10
11