Tuner Functions; Manual Search Of Radio Stations; Automatic Search Of Radio Stations; Direct Tuning To A Radio Frequency - Audio Pro STEREO TWO Operating Instructions Manual

TUNER FUNcTiONS

Manual search of FM/aM radio stations
Select TUNER as an audio source using the SOURCE
button. Select FM-stereo, FM-mono or AM with the
FM/AM button.
On the remote control, use the INPUT and BAND
buttons.
Turn the TUNING knob to the right to search up on
the radio dial or to the left to search down on the
radio dial. (The manual search option is only available
on the head unit).
automatic search of FM/aM radio stations
Using the SOURCE button, select TUNER as an
audio source.
Using the FM/AM button, select FM-stereo, FM-
mono or AM.
Press AUTO TUNE - or +. By pressing +, the next
station up the dial is located. Press the button again
to search further. Press on – for an equivalent search
down the dial.
Use the TUNING button on the remote control to
perform these functions.

direct tuning to a radio frequency

(This option is only available with the remote control).
Example : To tune in to frequency FM 07.60 MHz:
Select FM. Press the ---/REP button on the remote
control. Enter the numbers in the following order:
,7,6,0.
Example : To tune in to frequency FM 89.90 MHz:
Select FM. Press the ---/REP button on the remote
control. Enter the numbers in the following order:
8,9,9,0.
Or
Or
And
Tuner pre-sets
A total of 80 FM and AM stations can be stored in
memory.
Locate a desired radio station (FM or AM). Open
the memory with the STOP MEMORY button on the
front panel or the MEMORY button on the remote
control.
Select the desired program number with the TONE/
SKIP button on the front panel or the numerical but-
tons on the remote control.
The program number and the MEM indicator will
blink on the display.
Press the STOP MEMORY button on the front panel
again or the MEMORY button on the remote control.
The radio station is now saved in memory.
The program number will stop blinking and the
MEM indicator will go off.
Repeat the above procedure to pre-set other radio
stations.
Locating pre-set radio stations
Using the SOURCE button, select TUNER as an
audio source.
Turn the TONE/SKIP button on the front panel or
press the PRESET button on the remote control to
select the desired program number.
display during radio listening
FM stereo
Tuned-in station
Is visible during a RDS broadcast
FM mono
Tuned-in station
Is visible during a RDS broadcast
Program
place
Stereo reception
FM stereo
Program FM Frequency
place
FM mono
FM Frequency