ACP RMS A Series Quick Start Manual

A
C
Preset Program Keys
To cook food using preprogrammed
cooking sequences:
1. Open oven door and place food in
oven. Close door.
2. Press desired Number Key
3. Oven begins cooking
4. At the end of the cooking cycle,
the oven beeps and LED displays
"End".
X2 - Double Quantity
Cooking
1. Open oven door and place food in
oven. Close door.
2. Press X2 key .
3. Press desired Preset Program
Number Key(s). LED displays the
cooking time for two quantities.
The oven will start cooking per the
quantity preset cooking time.
The switching operation of this microwave oven can cause voltage fluctuations on the supply line. The operation of this oven under unfavorable
voltage supply conditions can have adverse effects. This device is intended for the connection to a power supply system with a maximum
permissible system impedance Zmax of 0.2 Ohms at the interface point of the user's supply. The user has to ensure that this device is connected
only to a power supply system which fulfills the requirement above. If necessary, the user can ask the public power supply company for the
system impedance at the interface point.
©2019 ACP, Inc.
Cedar Rapids, IA 52404
Quick Start Guide
Refer to Owner's Manual for Safety Statements. Complete Owner's Manual available online.
This document covers RMS*A and MMS*A models with touchpad controls
OVEN CLEARANCES
A. Allow at least 7" (17.78 cm) of clearance around top of oven. Proper air flow
around oven cools electrical components. With restricted air flow, oven may not
operate properly and life of electrical parts is reduced.
B. There is not an installation clearance requirement for the back of the oven.
C. Allow at least 1" (2.54 cm) of clearance around sides of oven.
B
D. Install oven so oven bottom is at least 3 feet (91.5 cm) above floor.
D
So...how do I use it?
Manual Time Entry Mode
Time entry mode allows the user to manually enter a cook time and power level.
1. Open oven door and place food in oven. Close door.
2. Press the TIME ENTRY key
3. Press Number Keys to enter the desired cook time.
4. Press POWER LEVEL key
5. If stage cooking is desired, press TIME ENTRY key
6. Press START key
7. At the end of the cooking cycle, the oven beeps and LED displays "End".
Programming Mode
1. Open oven door and press and hold Number Key "1" for 5 seconds.
2. Press a Number Key to change or review a Preset Program setting.
3. Press Number Keys to enter the new desired cook time.
4. Press POWER LEVEL key
5. If stage cooking is desired, press TIME ENTRY key
6. Press START key
7. Close the door to exit Programming Mode.
Note: If STOP/RESET key
complete,changes are discarded and microwave exits programming mode.
(Electronic Control)
.
, , or to change power level if desired.
to begin cooking.
, , or to change power level if desired.
to save the cooking program.
is pressed before programming is
and repeat steps 2-4.
and repeat steps 3-5.
Part No. 20267702
Original Instructions