Labels Used On The Chair; Safety; Application - VELA Medical X-Ray Chair Instructions For Use Manual

IN GENERAL

1.4. LABELS USED ON THE CHAIR

Warning
Icon
Icon
Labels
Labels on the chair should be read at a distance of approx. 40 cm under normal
daylight conditions.
For labels related to the operation of the chair, please refer to section 2.0.

1.5. SAFETY

This chair bears the CE mark and
approved under the model name
"VELA Tango" and conforms to all
applicable EU rules. The chair is
manufactured by VELA Medical,
Goeteborgvej 8-12, 9200 Aalborg
SV, Denmark.
The VELA Tango with electrical func-
tions meets all safety requirements
according to IEC 60601-1, including
requirements for EMC according to
IEC60601-1-2.
Risk of shear and squeeze:
Keep hands and fingers away from moving parts
Read "Instruction For Use" before use
Part used:
Type B cf. IEC60601-1
covering the following areas of the chair:
60 x 22.5 mm
This label only applies to
chairs with electrical functions:
The chair is IP21 approved,
which corresponds to protection against
water droplets as well as against touching dangerous parts with a finger.
<Model name>
<Model ref no.>
<Manufacturer>
<Adress>
<Webpage>
IdentNo.: <IdentNo.>
Follow instructions
for use
EN60601-1 Duty cycle: 10%,
max. 2min/18min Storage limits
IP21
Blade fuse: 10A/32V,

1.5.1. APPLICATION

This chair is an indoor chair
intended for sitting.
:: The chair is not built to stand on
:: The wheel brake must always be
activated when sitting down or
standing up
All variants of this chair are tested
and approved for a maximum load
of 160 kg.
<ME Equipment mass>
<Safe Working load>
<Production date/order no.>
Input:
24V
0.5A
60°C
-20°C
7