Strolling Bracket; Charging (El); Electric Brake (El); Setting The Angle Of The Brake - VELA Medical X-Ray Chair Instructions For Use Manual

EL
1 4

2.0.16. STROLLING BRACKET*

Strolling bracket for transporting a person in the chair. The
strolling bracket is mounted to fittings under the seat using
two finger screws. This is also where the depth is adjusted. The
height is adjusted by pressing the two buttons on the side of
the bracket while the handle is positioned at the desired height.

2.0.17. CHARGING (EL)

Daily charging is recommended . Remove the operation plug
EL
from the back of the armrest and place it in the charger as
shown. The charger is plugged into an electrical outlet. When
the chair is charging, the LED on the charger is yellow. When
the chair is fully charged, the LED turns green.
Note: The chair should not be used during charging.

2.0.18. ELECTRIC BRAKE (EL)*

The electric brake is activated and deactivated using the hand
box or switches. It is advisable to activate or deactivate the
brake completely when using this feature.
Note: The brake can only be used via switches under the
armrest, the hand box, or angle switch.

2.0.19. SETTING THE ANGLE OF THE BRAKE*

Loosen the thumbscrew and remove the brake rod from the
holder. Insert the brake rod in the desired side and angle.
Remember to retighten the thumbscrew.
Note: The brake can be set at 30° intervals. The brake rod can be
moved forwards/backwards and closer to/further from the seat
as required. The brake can also be moved to the opposite side.