Switching Fuel Tanks - DARLEY 2BE6.5H Operator's Manual

Switching Fuel Tanks While The Engine Is Running:
DANGER: CONTENTS OF THE FUEL CAN ARE FLAMMABLE OR
COMBUSTIBLE VAPORS CAN EXPLODE. HARMFUL IF SWALLOWED.
If swallowed, do not induce vomiting, call physician.
Keep out of reach of children.
Avoid prolonged breathing vapors.
Do not siphon by mouth.
Do not refill or store in vehicle, aircraft or living space.
Store and use in a well-ventilated area.
Vapors can be ignited by a spark or flame source. Keep away from flame, pilot
lights, stoves, heaters, electric motors, and other sources of ignition.
Keep container closed when in use.
Fill without spilling.
1. Have a fuel can filled with 86 octane or higher gasoline close by, ready to be installed.
WARNING: Keep all fuel cans and gasoline away from the exhaust muffler and the path of the exhaust,
to avoid possible combustion.
2. Disconnect the two fuel tank retaining straps.
3. NOTE: After this step you will have approximately 30 seconds to do steps 4 and 5 before the engine
stops.
Disconnect the fuel line from the spent fuel can by pressing the metal tab on the female quick disconnect
on the fuel can and pull out on the male fitting on the fuel line.
4. Replace the spent fuel can with the full fuel can so that the end of the fuel can with the fuel fitting is
closest to the throttle.
5. Connect the fuel line to the full fuel tank by pushing the male quick disconnect on the fuel line into the
female quick disconnect on the fuel tank.
6. Reconnect the two fuel tank retaining straps.
NOTE: For optimal engine performance and engine life, always use strained or filtered
gasoline with an octane rating of 86 or higher.
NOTE: The fuel tank contains adequate fuel for four hours of run time.
Prepared by: TED
Approved by: MCR
© W.S. Darley & Co.
6
Rev. #: 13
15May2006
1200569.doc