Pump And Accessory Maintenance - DARLEY 2BE6.5H Operator's Manual

Pump & Accessory Maintenance:
2BE6.5H PUMP AND ACCESSORY MAINTENANCE REQUIREMENTS
SYSTEM ID ACTION
Pump Replace seal
Assembly
(end)
Replace sleeve (seal)
Replace discharge check valve
Replace discharge check valve
assembly
Replace impeller
Replace inboard head
Priming Check hand priming pump/
System replace assembly upon failure
Replace pump
Replace check valve
2BE6.5H hand primer kit:
- Replace primer cup
- Replace bumper(s)
Replace hand primer hose
Replace 3/8 NPT 90 deg. elbow
Replace cup washer
Replace cylinder
Replace cylinder head
Replace 1/4 NPT 90 deg. elbow
Replace end cap
Replace handle
Replace hex nut
Replace piston nut
Replace piston rod
Replace soc head cap screw
Prepared by: TED
Approved by: MCR
© W.S. Darley & Co.
INTERVAL MNT LVL SPARES REQUIRED/DWG NO.
Upon failure Unit Seal/Furon Mechanical, 1.12, p/n 1843400
(See dwgs. #DBC0503 & #1201004)
Upon failure Depot Sleeve/Seal, p/n 1843300 (dwg. #DBC0503)
Upon failure Unit Body - Discharge Check Valve, p/n 2056000
(See dwg. #DBC0502)
Upon failure Depot Gasket - Disch Ch Valve Assy, p/n 3821301
(See dwg. #DBC0502)
Upon failure Depot Impeller, p/n 2907700
(See dwg. #DBC0502)
Upon failure Unit Head, inboard, 2BE6.5H, p/n 2810001
(See dwg. #DBC0503)
Yearly Unit Primer Assembly, p/n AP00314
(See dwg. #DGC0214)
Upon failure Depot (See dwg. #DBC0502)
Upon failure Unit Check valve, primer, p/n 5201704
(See dwg. #DGC0214 for all below)
Upon failure Unit Piston Cup, p/n 4405700
Upon failure Unit Bumper, p/n 4426300 & Bumper, 4426301
Upon failure Unit Hose, hand primer, p/n 4402392
Upon failure Depot 3/8 elbow, p/n 3502011
Upon failure Depot Cup washer, p/n 3603716
Upon failure Depot Cylinder, p/n 1020602
Upon failure Depot Cylinder head, p/n 2802502
Upon failure Depot 1/4 elbow, p/n 3502010
Upon failure Depot End cap, p/n 2501803
Upon failure Depot Handle, p/n 3001002
Upon failure Depot Hex nut, p/n 5403207
Upon failure Depot Piston nut, p/n 5403467
Upon failure Depot Piston rod, p/n 1041001
Upon failure Depot Soc head cap screw, p/n 5402627
31
TOOLS/SE REQUIRED
X4926 Seal Pressing tool
1.5" Diameter Metal Bar
(about 6" to 8" long)
Marine Grade Grease
X4872 Seal Sleeve Press tool
Loctite 243 or equivalent
Wrench for 3/8" head
5/16" Allen Wrench
Allen socket
1/2" Wrench
1/2" Socket
1" Socket
1/2" wrench, 1/2" flex socket,
5/16" Allen Wrench, Allen
socket
3/32" Allen Wrench
7/16" deep socket
5/8" wrench
1/2" wrench
Rev. #: 13
15May2006
1200569.doc
PMS NUMBER