Shutting Down And Stowing The Pump - DARLEY 2BE6.5H Operator's Manual

12. Once the pump is primed and discharging water, slowly opening the engine throttle, by pushing the
throttle lever to the left until full throttle position, increases the pump's discharge flow capability.

Shutting Down and Stowing the Pump:

1. Return the throttle to the "IDLE" position.
2. Close the fuel valve by pushing it to the left to the "OFF" position.
3. Shut down the engine by turning the ignition switch counter clockwise to the "OFF" position.
4. Disconnect the suction and discharge hoses.
5. Tip the unit toward the pump's discharge to drain the water. After all water is drained, return the pump to
its normal upright position.
6. Operate the primer a few times to purge it of water.
7. Flush the pump with fresh water and operate the hand primer.
8. Tip the unit toward the pump's discharge to drain the water. After all water is drained, return the pump to
its normal upright position.
9. Operate the primer a few times to purge it of water.
10. Check the engine oil and engine fuel levels and add as necessary to prepare the unit for its next use.
11. Flush and drain the hoses; coil for restowing.
12. Spray the interior, exterior, and face of the pump's discharge, suction inlet and impeller with a
silicone lubricant spray.
13. Allow the entire contents to dry before sealing it into the storage container.
14. Return unit to its ready state for its next usage.
15. Restow the pump unit and hoses in the pump kit container.
WARNING:
Read and Understand the Honda GX200 Engine's Owner's Manual Before Operating This Unit
Prepared by: TED
Approved by: MCR
© W.S. Darley & Co.
If any problems with the pump are encountered during or after
operation, do not repack the pump.
personnel of any problems encountered during or after
operations.
5
Notify maintenance
Rev. #: 13
15May2006
1200569.doc