Cli Command Explanations - ATTO Technology FastStream SC 5500 Installation And Operation Manual

Command
VerboseMode
VirtualDriveInfo
WrapEventLog
Zmodem

CLI command explanations

AutoMap
Automatically maps each RAID partition to a Fibre Channel LUN
up to maximum of 256 maps. All previous maps are deleted.
AutoMap
AutoResume
Regulates or lists the status of interrupted rebuild, erase and
initialization operations at startup. If no Group Name is
specified, the command operates on all existing RAID groups.
set AutoResume [Rebuild|Erase|Initialization|all]
[enabled|disabled] <Group Name>
get AutoResume [Rebuild|Erase|Initialization|all]
BlockDevClean
Removes any RAID configuration data from the block device
with the specified BlockDevID.
BlockDevClean [BlockDevID]
BlockDevIdentify
Lights the LED of a disk drive. Use either RAID group name and
Member Index, or BlockDevID.
BlockDevIdentify [ [Group Name| Member Index]
|BlockDevID]
BlockDevIDStop
Turns off the IO LED of a previously identified disk drive.
BlockDevIDStop
BlockDevScan
Lists all currently connected physical block devices along with
any potential RAID group association. Each block device listed
is assigned a unique index at the time of the scan.
BlockDevScan
BootDelay
Regulates the delay in seconds after startup before allowing
hosts to detect discovered targets.
Default: 5
set BootDelay [0 - 255]
get BootDelay
Default Example
enabled set verbosemode disabled
virtualdriveinfo
enabled set wrapeventlog disabled
zmodem receive
BridgeModel
Reports the specific model and firmware information to the CLI.
get BridgeModel
BridgeName
Provides a descriptive ASCII name assigned to the unit to
identify individual units. The specified name can be up to a
maximum of eight characters. Changes to bridge name take
effect immediately.
Default: " "
set BridgeName [name]
get BridgeName
ClearEventLog
Clears the contents of the event log.
ClearEventLog
Date
Regulates or lists the current date. The date range is
01/01/2000 to 12/31/2099.
set Date [MM/DD/YYYY]
get Date
DeleteAllMaps
Removes all mapped devices from the map table. Upon the
subsequent POST, if no maps are present the default maps are
loaded.
DeleteAllMaps
DisplayEventLog
Displays the EventLog.The event log may be filtered using the
DisplayEventLogFilter
executed, facilitates scrolling through the event log using +,| -, =
and q. The optional parameter is the number of lines to be
displayed as a single page with no user interaction.
DisplayEventLog <n>
command. After the command has
vi