Faststream Sc 7700 Physical Attributes; Dimensions; Cooling And Airflow; Power - ATTO Technology FastStream SC 5500 Installation And Operation Manual

1.3 FastStream SC 7700 Physical Attributes

The ATTO FastStream SC 7700 is a Fibre Channel to Fibre Channel storage controller which can be seamlessly
integrated into an existing storage environment.
The ATTO FastStream SC 7700 is available in a
desktop model and in an industry-standard 1U form
factor for easy integration into racks. It supports next-
generation media and is equipped to handle the
throughputs needed by advanced disk technologies.
For installation instructions, refer to
FastStream on page 11.

Dimensions

Width: 17.31 inches
Length: 9.9 inches
Height: 1.69 inches (1U)
Weight: approximately 8 pounds

Cooling and airflow

Operating Temperature: 5°-40° C
Humidity: 10-90% non-condensing
CAUTION CAUTION
Do not block the enclosure's vents. The
FastStream does not allow data transfer if
overheating occurs. Ambient air should
not exceed 40° C.

Power

Input voltage: 100-240 VAC, 2.5A, 47-63 Hz
Battery-backed event log: A rechargeable Lithium
ion battery cell holds the event log memory for up to 30
days. If the FastStream has been disconnected from
power, recharging begins automatically when power is
restored to the system. The battery is fully charged
after 36 hours of continuous power application.
WARNING
WARNING
Risk of explosion if battery is removed
and/or replaced by an incorrect type.
Dispose of used batteries in accordance
with your local environmental regulations.
Explosionsgefahr, wenn die Batterie falsch
entfernt und/oder ersetzt wird. Entsorgen
Sie benutzte Batterien in Übereinstimmung
mit Ihren lokalen
Umweltschutzbestimmungen.

Fibre Channel ports

The four independent 4-Gigabit Fibre Channel ports
connect the FastStream to Fibre Channel hosts using
optical SFP connectors and multimode fiber optic
cable.
Install the
Ports 1 and 2 connect to the host computer; ports 3
and 4 connect to devices (see

Management ports

Management is provided using the 10/100/1000 base
T Ethernet port accessible from the RJ-45 connector
or the RS-232 serial port using an RJ-11 connector.
(See

Reset/restore factory default switch

To reset the FastStream, briefly insert a tool in the
reset hole in the back panel for less than three
seconds. See
To restore factory defaults, insert the tool in the reset
hole in the back panel for more than four seconds until
the green Ready LED blinks.

LED indicators

The LED indicators can be viewed from the connector
side and the front side of the FastStream. (See
1.3-1
LEDs on the connector side are:
Ready/Fault LED lights green to indicate ready,
lights yellow to show a faulted condition, and is off to
indicate not ready.
Ethernet port connector: a lighted green LED
shows a valid link, off indicates that no link is present,
and blinking indicates activity. A separate bicolor LED
indicates 10/100/1000 MbE speed: green indicates
100 MbE, yellow indicates 1000 MbE, and off indicates
10 MbE.
Fibre Channel port: a lighted green LED indicates
link and off means no link. A separate green LED
indicates FC speed, lit indicates 4-Gb/sec, and off
indicates 1- or 2-Gb/sec.
LEDs on the faceplate are:
A Ready LED is lighted green to indicate ready and
off to show not ready.
An Alert LED is lighted yellow to show an alert
condition.
Exhibit 1.3-1).
Exhibit 1.3-2.
and Exhibit 1.3-3)
Exhibit 1.3-1).
Exhibit
7