Related Manuals for Lasermet LS-100-12
Summary of Contents for Lasermet LS-100-12
- Page 1 LS-100-12 Laser Beam Shutter Instruction Manual LASERMET LS-100-12 SHUTTER INSTRUCTION MANUAL GRAVITY FED, FAIL-SAFE LASER BEAM SHUTTER FOR SAFETY APPLICATIONS CEB00XXX-53-000 Issue 4 19 January 2021...
-
Page 2: Table Of Contents
LS-100-12 Laser Beam Shutter Instruction Manual LASERMET LS-100-12 Instruction Manual Contents Declaration of Conformity ....................3 Safety Warnings ........................4 Concept ..........................5 Installation .......................... 5 Wiring ..........................5 Operation ..........................6 Specifications ........................7 Warranty ..........................8 Contact Details ........................9... -
Page 3: Declaration Of Conformity
LASER BEAM SHUTTER Part no. LS-100-12 DECLARATION OF CONFORMITY This is to certify that the Laser Beam Shutter designated by Lasermet Part Number LS- 100-12 has been tested in accordance with the following directives and standards and found to comply. -
Page 4: Safety Warnings
LS-100-12 Laser Beam Shutter Instruction Manual Safety Warnings This device is intended to be used as part of a safety system which may be used to protect personnel and equipment from possible injury, damage, or loss. As such it must be installed and wired according to these instructions and tested by suitably qualified persons. -
Page 5: Concept
The LS-100-12 is designed as a combined shutter and beam dump and will not reflect the beam back out of the shutter. Consequently, there is no requirement for an additional beam dump. When used for safety interlocking the shutter input tube should be butted up against the laser to totally enclose the beam and ensure that there is no accessible laser beam when the shutter is closed. -
Page 6: Operation
Shutter’ switch. Wire a normally open switch across Pin’s 3 and 4. This will be the remote ‘Open Shutter’ switch. The existing pushbuttons will still work as normal. A remote switching unit (part number: LS-RS) with indication LEDs is available from Lasermet. Bypass of Open & Close Switches This is set by the manufacturer. -
Page 7: Specifications
The End User is responsible for the safe use of this product and Lasermet Ltd. or its agents shall not be liable for any damage or injury caused by the use or misuse of this product. In the event of defective product liability shall be limited to the value of the product. -
Page 8: Warranty
LS-100-12 Laser Beam Shutter Instruction Manual Warranty Lasermet provide a 12-month warranty for defects in materials and manufacture, from the date of installation or delivery. Installations completed by Lasermet are covered against defects in workmanship for 12 months. Damage or defects caused by other factors are not covered. For example, industrial contamination, incorrect cleaning, storm damage. -
Page 9: Contact Details
LS-100-12 Laser Beam Shutter Instruction Manual Contact Details Lasermet provide a full range of laser interlock equipment including interlock switches, illuminated warning signs, laser shutters, entry keypads with built-in fail-safe override timer, door locks, external power supplies etc. which can be interconnected to provide a complete system. We also supply equipment and consultancy covering all aspects of laser safety.