Canyon SPEEDMAX Manual page 20

36 ADJUSTING TO THE RIDER EXTENSIONS AND ARMRESTS
Adjusting the mono grips
The angle of the mono grips can be adjusted. Ob‑
serve that the right and left grip are connected
with a small spacer. Therefore they have always to
be adjusted to the same angle. The angle cannot
be adjusted for each grip individually.
The position of the mono grips on the mono ex‑
tension can also be adjusted horizontally in length.
Prior to this adjustment the two countersunk
bolts must be loosened. The range of adjustment
is limited towards the front and the rear.
The FITTING KIT includes two grip width spacers
that can be used to enlarge the distance between
the grips. When using the grip width spacers, be
sure to use the long bolt supplied.
Adjusting the armrests
If you want to change the position of the armrests,
remove the foam pads from the armrests first.
Loosen the two fixing bolts respectively on both
sides.
EXTENSIONS AND ARMRESTS
You can mount the armrests lengthways in three
different positions and sideways in two different
positions.
The screwing in the oblong holes also allows a
limited adjustment of the armrest angle in the
horizontal plane.
No matter which mounting position of
the armrests you opt for, always make
sure that two fixing bolts per armrest are in‑
serted one after the other in one line. Risk of
breakage!
ADJUSTING TO THE RIDER
Insert the fixing bolts into the thread holes as far
apart from each other as possible and tighten
them to the indicated torque value of 2.5 Nm.
Check the firm seat of the armrests.
Finish by fixing the foam pads with the Velcro fas‑
tener to the armrests. Make a test ride to check
the seating position.
Prior to adjusting the height and the tilt, i.e. when
changing the spacers included in the FITTING KIT,
you have to dismount the cover.
37