Page 1
TECHNOLOGY IN MOTION MACO MULTI TURN-ONLY AND TURN&TILT HARDWARE Maintenance and adjustment instructions for turn-only, turn&tilt, tilt-first and tilt windows CERTIFIED SPECIALIST m a c o . e u...
Contents Safety and warning information 3 - 4 Measures to preserve the surface finish Setting the turn-only, turn&tilt and tilt-first sash 6 - 11 Setting the scissor stay or turn-only hinge - sash part – lift/lower 6 - 7 Setting the scissor stay or turn-only hinge – gasket compression 7 - 8 Pivot post setting 9 - 11 Tilt-only sash setting...
Safety and warning information WARNING! Risk of injury due to improper maintenance operations. Improper maintenance can lead to serious personal injury or material damage. For this reason: › Before starting work, ensure there is sufficient room for carrying out assembly work. ›...
Page 4
NOTE! Warranty claims can only be accepted if all maintenance operations have been carried out in full and according to the maintenance intervals (specified in the end user operating instructions), and this can be verified. NOTE! Warranty claims can only be accepted if the unit has been installed correctly and by a certified specialist.
Measures to preserve the surface finish Protection against soiling: › The hardware should be kept free of debris and soiling. Immediately remove soiling during the building stage caused by plaster, mortar or similar with water. › Protect hardware components from contamination (dust, dirt, paint, etc.).
Page 6
Adjustment values are always specified in regard to the hinge-side air gap and/or the bottom horizontal air gap. Setting scissor stay or turn-only hinge 1. Lift/lower › MULTI-MATIC / MULTI-TREND corner hinge version max. 1 +2,85 / -1,8 DANGER! The adjusting screw...
Page 7
› MULTI-MATIC / MULTI-TREND stay and hinge -3 / +5 DANGER! The sash may only be lowered to the third notch and/or to the red mark, otherwise the sash can fall out! › MULTI MAMMUT -4,1 / +1,7 The side adjustment of the scissor stays up to version 2 requires the mandatory use of feeler gauge item no.
Page 9
› MULTI-MATIC turn-only hinge - sash part -1,5 / +1,5 › MULTI POWER scissor stay -0,7 / +0,7 › MULTI POWER turn-only hinge - sash part -1 / +1 - 9 -...
Hinging and unhinging the sash › MULTI-MATIC / MULTI-TREND scissor stay hinge – PVC / DT / AS Correct position of the DANGER! pin after hinging 1. Remove the cover, if there is one. 2. Pull the scissor stay-hinge pin downwards with a suitable tool. The scissor stay hinge pin can only be withdrawn when the window is closed.
Page 16
› MULTI MAMMUT scissor stay hinge 1. Remove the locking screw. 2. Remove the scissor stay hinge pin. 3. Pull the scissor stay hinge pin downwards and open the sash 90°. 4. Move the rebated scissor stay support arm out of the scissor stay hinge and lift the sash out of the pivot post.
Exchange of window rebate seals › When exchanging window rebate seals, it is important to ensure that a suitable seal is used. Installing an unsuitable seal can negatively affect the functionality, performance and operation of the window (driving rain tightness, air flow, operating force when locking…).
Page 20
TECHNOLOGY IN MOTION MACO near you: www.maco.eu/contact Created: 05/2015 - Changed: 09.03.2020 Order no. 757070EN All rights reserved and subject to change. This print document is revised regularly. The latest version is available at https://www.maco.eu/assets/757070en or scan the QR code.