Related Manuals for Maco SKB-SE
Summary of Contents for Maco SKB-SE
- Page 1 TECHNOLOGY IN MOTION MACO RAIL-SYSTEMS SLIDING HARDWARE Maintenance and adjustment instructions for SKB standard, self-engaging, positive control and PAS CERTIFIED SPECIALIST m a c o . e u...
-
Page 2: Table Of Contents
Table of contents Intended purpose and misuse 3 - 4 Measures to preserve the surface finish Adjustment options 6 - 9 Hinging and unhinging the sash 10 - 12 Spare parts, customer service WARNING! These maintenance instructions are only intended for certified specialists and their trained employees. -
Page 3: Intended Purpose And Misuse
Intended purpose and misuse In the case of vertically installed windows or casement doors with sliding hardware in high building construction, these are shifted horizontally, tilted or parallel stopped by operating a window handle. When closing a sash and when locking the hardware in place, the resistance of the seal must be overcome as a rule. - Page 4 packageleaflet.Oncehardwarecomponentshave beenreplaced,theassemblyfixingmustbe„torn through“ as necessary. You must always check that the repaired sash functions correctly! NOTE! Warranty claims can only be accepted if all maintenance operations have been carried out in full andaccordingtothemaintenanceintervals(specified intheenduseroperatinginstructions),andthiscan beverified. NOTE! Warranty claims can only be accepted if the unit has beeninstalledcorrectlyandbyacertifiedspecialist.
-
Page 5: Measures To Preserve The Surface Finish
Measures to preserve the surface-finish Protection against soiling › The hardware should be kept free of deposits and soiling. Immediately remove soiling during the building stage caused by plaster, mortar or similar with water. › P rotecthardwarecomponentsfromcontamination(dust,dirt, paint,etc.). Protection against corrosion ›... -
Page 6: Adjustment Options
Adjustment options SKB-S, SKB-SE, SKB-Z, and PAS CAUTION! Settings and adjustments for the hardware, including hinging and unhinging the window or casement door, must only be carried out by certified specialists. Adjusting the SKB-S sash lifter MULTI-TREND MULTI-MATIC Release the screw... - Page 7 Regulating the height of the roller > 11 mm 11 = 0 ≠ Torx 40 5 =+6 PAS / SKB-Z 200kg > 11 mm 11 = 0 5 =+6 Torx 40 - 7 -...
- Page 8 Torx 25 4 .. 5 Nm 2 .. 3 Nm SKB-Z ≠ 12 mm 12 mm SKB-SE Adjusting the gasket compression min. Torx 15 max. Adjusting the PAS reinforcement parts A - Make run-in easier B - Make run-out easier max.
- Page 9 Adjusting the SKB-S, SKB-SE, SKB-Z stop buffers Torx 25 3 ... 4 Nm A ≠ 0 Torx 25 B ≠ 0 2 ... 3 Nm Adjusting the PAS stop buffers Torx 25 3 ... 4 Nm Torx 25 A ≠ 0 2 ...
-
Page 10: Hinging And Unhinging The Sash
Hinging and unhinging the sash Certified specialists must pay particular attention to the following points, since the installation no longer lies within the sphere of influence of the hardware manufacturer. SKB-S, SKB-SE, SKB-Z A - B - C -10-... - Page 11 A - B - C - D > 0 A - B - C - D - E - F F - E - D - D1 - C - B - A Torx 25 2 . 3 Nm -11-...
- Page 12 Torx 25, 3.. 4Nm CAUTION! If the scissor stay pins do not snap in the sliders securely and properly, the window sash will not be held securely and may fall out. This can result in serious bodily injury or death. CAUTION! If the anti-jemmy device is not (or not correctly) latched in place at the marked position, the window...
-
Page 13: Spare Parts, Customer Service
Spare parts, customer service Spare parts or customer services can be acquired from window suppliers or window manufacturers. A list of manufacturers and dealers can be found at www.maco.eu. Disposal Disposal of hardware must comply with local regulations or laws. Applied standards ÖNEN14351:2010 Windowsanddoors-productstandard... - Page 14 Notes -14-...
- Page 15 Notes -15-...
- Page 16 TECHNOLOGY IN MOTION MACO in your area: www.maco.eu/contact Order No. 757962 – Date: 06/2017 All rights reserved and subject to change. Graphic source: MACO This print document is revised regularly. The latest version is available at https://www.maco.eu/assets/757962 or by scanning the QR code.