Preparation For Operation; Camera Adapter - ATN MO2-1 User Manual

PREPARATION FOR
OPERATION
Before getting started make sure to follow these steps:
• Take the monocular out of the case.
• Install the battery into the housing with the polarity order shown
on imprint on the body. Battery type: 3 Volt Lithium, #CR123A
• Switch on the monocular with the protective lens cover still
attached to the lens.
• Make sure that the green luminance of the light intensifier tube is
present.
• If the device is not to be used for extended period of time (more
than 10 days) remove the battery.
• Avoid touching lenses. If fingerprints or traces of dirt or dust
appear, clean surface with a soft dust cloth and glass cleaner.
• Keep lens cap/daylight filter on when not in use.
• Avoid contact with dust, steam, and gas.
• The MO 2-1 is not harmful to the user or the environment.
• Do not disassemble except to clean the front lens and the eye-
piece: it will void your warranty.
• Evaluate the scopes function by looking through it in a lit environ-
ment with the daylight filter lens cap on. Never use in daylight
without the daylight filter lens cap on.

CAMERA ADAPTER

To use your MO 2-1 scope with a 35-mm camera or
camcorder you will need the following:
1) If you plan to use a camcorder, then your
camcorder must have a MACRO feature. Most
modern camcorders today have a MACRO fea-
ture built-in.
2) If you plan to use a 35-mm camera you will need
a MACRO lens. If you don't have one we advise
that you contact your local camera store.
3) You may or may not need a STEP-UP or STEP-
DOWN ring in order to adapt the camera adapter
to your lens.
NOTE: The camera adapter comes with 37-mm and
52-mm threads. If you need other sizes your local
camera store should be able to help.
• Remove the rubber eyecup from the scope.
• Screw the camera adapter onto the front of the lens on your Video
camera lens or your 35-mm camera lens.
• Loosen the three set screws on the camera adapter.
• Place the camera adapter over the scope's eyepiece.
• Tighten the three set screws to fit snugly to the scope's eyepiece
3
Camera adapter
Joint ring