Advertisement
D.
Fitting the antenna
Ensure that the cable exits the back of the arm in the correct direction.
Wall Mounting
Use the end of the dipole arm as a template to mark the mounting
holes, ensuring that the antenna will be vertical.
Drill holes, and secure the arm to the wall using suitable screws and
wall plugs as required. (not supplied).
Mast Mounting
The dipole arm can be secured by self-tapping screws directly into the
mast or by heavy duty, UV resistant nylon cable ties.
E.
Routing and terminating coaxial cable(s)
Route the cable away from the antenna, securing at regular intervals along the length. Care should be taken to
use correct size clips to ensure cable is not compressed. If using cable ties, these should not be overtightened.
On entry to a building or enclosure, a "drip loop" should be provided to avoid water ingress by running along the
cable.
Fit a suitable connector if not already supplied.
F .
Commission and test
Carry out a VSWR test – this should comply with value stated in product data sheet.
Connect antenna to radio terminal and carry out an "on air" check.
G.
Notices
European Waste Electronic Equipment Directive 2002/96/EC
Please ensure that your old Waste Electricals and Electronics are recycled do not throw them
away into standard waste.
RF Safety Note
This antenna should be mounted in such a way that no person is within 30cm (12") of the
antenna during use.
RoHS 2: EU RoHS compliance is declared per Directive 2011/65/EU and its subsequent amend-
ments. Homogeneous materials composing parts that are compliant with this legislation have less
than 0.1% by weight each of lead, mercury, hexavalent chromium, PBB, and PBDE, and 0.01% by
weight of cadmium. In situations where an exemption applies, the preceding limits, corresponding
to the exempted substance(s), may be higher.
Waiver: This document represents information compiled to the best of our present knowledge. It is not intended to as a representation or warranty of fitness
of the products described for any particular purpose. This document details guidelines for general information purposes only. Always seek specialist advice
when planning installations and ensure that antennas are always installed by a properly qualified installer in compliance with local laws and regulations.
4 HOLES
5.1
Advertisement
