Hartzell HC-D2MV20-3 Series Owner's Manual And Logbook page 194

WARNING:
CAUTION:
(6) Apply sufficient finish coating to achieve 2 to 4 mils
thickness when dry. Re-coat before 30 minutes, or after
48 hours. If the paint is allowed to dry longer than four
(4) hours, it must be lightly sanded before another coat
is applied.
(7) Remove the masking from the tip stripes and re-mask to
allow for the tip stripe refinishing, if required.
(8) Apply sufficient tip stripe coating to achieve 2 to 4 mils
thickness when dry. Re-coat before 30 minutes, or after
48 hours. If the paint is allowed to dry longer than four
(4) hours, it must be lightly sanded before another coat
is applied.
(9) Remove the masking immediately from the de-ice boot
and tip stripes, if required.
(10)Optionally, perform dynamic balancing in accordance
with the procedures and limitations specified in Dynamic
Balance section of this chapter.
Maintenance Practices
Propeller Owner's Manual
FINISH COATINGS ARE FLAMMABLE
AND TOXIC TO THE SKIN. EYES AND
RESPIRATORY TRACT. SKIN AND EYE
PROTECTION ARE REQUIRED. AVOID
PROLONGED CONTACT. USE IN WELL
VENTILATED AREA.
APPLY FINISH COATING ONLY TO THE
DEGREE REQUIRED TO UNIFORMLY
COVER THE REPAIR/EROSION. AVOID
EXCESSIVE PAINT BUILDUP ALONG THE
TRAILING EDGE TO AVOID CHANGING
BLADE PROFILE.
61-00-40
140
Rev. 2 Jun/12
Page 6-16