Tele System P-link 0.1 User Manual page 14

P-Link 0.1
1 Safety Regulation
We advise you to read the following advice concerning the safety regulations carefully in order to ensure safe use of
the appliance.
ELECTRICAL SUPPLY
The appliance should only be supplied by a current of 100-240 Volt AC, 50/60 Hz. The appliance must not be
repaired in any way by the user, in case of breakages or failures pleae refer to the nearest center for assistance. Do
not remove the cover. The inside of the appliance could contain higher voltages than that of the supply voltage which
could endanger the user. High voltage is also present when the appliance is on standby. The receiver should be
disconnected from the electrical supply before performing any intervention. Non-authorised removal of any part
of the product will mean that the warranty is no longer valid!
INSTALLATION
Before installing the appliance make sure that the device is intact, paying particular attention to its connection to
the power supply. If the device is damaged do not attempt to connect the appliance and refer the problem to an
authorised center for assistance. Avoid placing the device in an area where it could accidentally be stepped on,
removed from the wall or damaged in any way. If the device is damaged in any way carefully disconnect from the
appliance and refer to specialised techinicans or the center for assistance to get a replacement.
LIQUIDS
Keep the appliance far from any liquids. Do not place any objects containing liquids on the appliance, such as vases,
humidifiers etc. The appliance must not be installed in areas where it could come into contact with sprays or drops
of water or in an environment with a high level of humidity where condensation could occur. If the product should
accidentally come into contact with liquids, disconnect immediately from the wall. DO NOT TOUCH the device until
it has been disconnected.
SMALL OBJECTS
Keep the device away from any small objects. Objects which fall into the appliance via the ventilation gaps could
cause serious damage.
CLEANING
Before cleaning, disconnect the device from the power supply. To clean the outside of the product use a soft and dry
or slightly damp cloth. Avoid using products which contain chemicals or solvents.
VENTILATION
Make sure that the area where the appliance is to be installed has good air circulation so that the heat can be
dissipate well in order to avoid overheating. In order to allow enough ventilation it is necessary to have a distance of
at least 10 cm on either side of the appliance and 15cm above the appliance. The vents must be kept clear from any
obstructions such as newspapers, table cloths, furnature material, curtains, carpets etc. Avoid installing the device
close to any heat sources (i.e. radiators, stoves etc) or on top of any other appliances which omit heat.
WARNING!!!
Keep the appliance out of reach of children. The plastic bags used for packaging can be dangerous. To avoid
suffocating keep the bags out of reach of children. Do not expose the receiver or remote control to direct sunlight.
The appliance must be placed on a solid and stable base.
Connect the device to the power supply only after installation is complete. Remove the batteries from
the remote control if they will not be used for a long period of time. The remote control could be
damaged by any eventual battery leakages. Dispose of the product correctly so as to avoid damage to
the environment and human health as well as to facilitate recycling of the components/materials used
in the appliance. If the product is not disposed of properly this could be punishable according to the
involved law. The manufacturers recommend that the parts are recycled seperately and are taken to
sites which conform to current regulations.
2