Master BC 341 User And Maintenance Book page 12

en
-DELAYED SWITCH-ON: When the cooler
is on, press the "TIMER" button repeat-
edly until the desired time is displayed (the
number flashes), then SWITCH OFF THE
COOLER.
-DELAYED SWITCH-OFF: When the cooler
is on, press the "TIMER" button repeatedly
until the desired time is displayed, then the
switch-off time is set.
NOTE: When the cooler emits an acoustic
beep, it means that the tank is empty and the
device is operating in fan mode. To restore
correct operation in "COOL" mode, refill the
water tank. To deactivate the acoustic beep,
deactivate the "COOL" function.
►►4.3. SWITCH-OFF:
►4.3.1. Press ON/OFF / POWER to turn off
the cooler (Fig. 7).
►4.3.2. Drain the tank through the specific
drain plug (Fig. 8).
►►5. CLEANING AND MAINTENANCE
WARNING: BEFORE PERFORMING ANY
MAINTENANCE OR REPAIR, DISCONNECT
THE POWER CABLE FROM THE MAINS.
DEPENDING ON
WHERE THE COOLER IS USED, DUST,
DIRT OR WATER QUALITY CAN AF-
FECT THE PERFORMANCE OF THE UNIT.
THEREFORE, CLEANING THE FOLLOW-
ING COMPONENTS MAY BE REQUIRED:
►►5.1. TANK:
IT IS RECOMMENDED TO READ THE
SAFETY WARNINGS CAREFULLY AND TO
CHANGE THE WATER FREQUENTLY.
►5.1.1. Turn off the cooler and disconnect
the plug from the power mains.
►5.1.2. Drain the tank through the specific
drain plug (Fig. 8).
►►5.2. EVAPORATIVE PANELS AND
WATER CIRCUIT:
►5.2.1. It is recommended to visually check
the condition and correct position of the
evaporative panels on a regular basis (Fig.
THE ENVIRONMENT
9). The panels must not be worn, damaged
or encrusted and must be positioned cor-
rectly in order to avoid gaps between each
other.
IMPORTANT: Do not attempt to remove
the evaporative panels. All operations must
be carried out by the after-sales assistance
service.
IMPORTANT: Handle the evaporative pan-
els with care; do not drill or insert pointed
objects in the air inlet grille.
►5.2.2. To ensure proper operation of the
cooler, turn off the COOL mode a few min-
utes before completely switching off the
cooler, in order to avoid stagnant water.
►5.2.3. We recommend periodically perform-
ing a complete cycle using clean water and
appropriate disinfection products, running
the cooler outdoors.
IMPORTANT:
-The cooler tank must be emptied and sani-
tised periodically depending on the use.
-The evaporative panel surfaces must be pe-
riodically inspected and sanitised depending
on the use.
-For sanitation operations, biocidal products
that comply with European regulation no.
582/2012 must be used.
►►6. REMOTE HUMIDISTAT CON-
NECTION (optional)
A remote humidistat can be connected in se-
ries to the power supply plug, to manage au-
tomatic switch-on or switch-off of the cooler.
After the humidistat has been activated, dur-
ing normal operation, the cooler switches off.
The re-ignition is automatic and the operating
configuration is restored keeping the settings
prior to switch-off.
CAUTION: THE ONLY SETTING THAT IS
NOT RESTORED IS THE "TIMER" FUNC-
TION, IN THIS CASE IN FACE THE COOL-
ER WILL GO IN STAND-BY CONDITION.