Midland M-88 Instruction Manual page 45

Inside each menu you will select the desired function and will confirm it by pushing
the main selector (14).
1. FUNCTIONS
1.1 DISPLAY BACKLIGHT
It is possible to adjust the display backlight; you can choose amongst 5
levels;
1.2 KEYPAD BACKLIGHT
To adjust the keypad backlight, 5 different backlight levels are available;
1.3 KEYPAD TONE
You can enable or disable the keypad beep everytime a button is pressed;
1.4 ROGER BEEP
When this function is enabled, the radio will emit an audio tone everyti-
me the transmission is finished.
1.5 AUTO POWER ON
When this function is on, if the radio is powered, it will automatically
switch on as soon as the vehicle is turned on.
1.6 POWER ON DISPLAY
With this option you can set the welcome message displayed when the
radio is turned on; you can choose amongst:
• PIC (shows the Midland logo and website)
• CHAR (shows MIDLAND POWER ON)
• BAT (shows the power voltage)
1.7 FACTORY RESET
Complete reset of the radio.
Select YES and press twice the main selector as confirmation (14).
Now all parameters and settings of the radio (also the frequency band)
will be reset to factory settings.
2. PARAM SET
2.1 SCAN MODE
With this function you can select how the scan will resume after having
received a signal; two options are available:
• TI: the scan will stop for some seconds on the received signal, then it
will start again on the other channels;
• SQ: the scan will stop when a signal is detected and will start again
only when the signal disappears.
2.2 STEP
This feature allows to set the frequency step. It can be done in three
different ways:
• Through the main selector (14)
16 | Midland 88 Instruction Guide