Appliance Assembly; Using The Appliance - MPM MOD-12 User Manual

1.
Suction power adjustment
2.
Storage clip
3.
Cord reel button
4.
On/Off switch
5.
Dust bag filling level indicator
6.
Upper lid
7.
Upper lid opening button
8.
Suction hose port
9.
Movable carrying handle
10. Carrying handle
11. Power cord
12. Filter cover
13. Filter HEPA 13
14. Textile dust bag (3.5 l)
ELECTROSTATICS
Cleaning some surfaces at low air humidity may cause slight electrification of the appliance. It
is a natural phenomenon which do not damage the appliance and is not its defect.
In order to minimize this phenomenon it is advised to:
 discharge the appliance by frequently touching metal objects with the wand,
 increasing air humidity in the room,
 using ordinary antistatic agents,

APPLIANCE ASSEMBLY

1. Insert the hose connection
is blocked. In order to disassemble, press the release button on the connection and remove
the hose from the connection port.
2. Connect the telescopic wand
one of the suction tools to the end of the telescopic wand. Crevice tool
stery nozzle with dusting brush
hose handle . Extend the telescopic wand to the preferred length by pressing the blocking
1(
button 1& and then release the button. The wand will be blocked in the chosen position.

USING THE APPLIANCE

1. Before turning on the vacuum cleaner pull out the power cord
and plug it into the socket. Yellow mark on the power cord indicates the optimal length. Do
not pull out the cord beyond the red mark! At pulling out the cord do not press the cord reel
button .
e
2. Press the ON/OFF switch
3. In order to reel the power cord, press the cord reel button
the cord with the other hand to avoid rapid movement which may cause damage.
Note! It is recommended to set the suction power control
15. Dust bag latch
16. Metal telescopic wand
17. Telescopic wand blocking button
18. Suction hose connection
19. Hose handle
20. Suction hose
21. Suction power control
22. Accessories holder
23. Carpet and floor brush
24. Small upholstery nozzle with dusting
25. Telescopic crevice tool
26. Motor filter
27. Rubber wheels
into the hose connection port
1*
to the handle
1^ 1(
are placed in the special accessories holder
2$
to turn on the vacuum cleaner.
r
q
brush
. You will hear a click when it
i
at the other end of the suction hose. Attach
to the preferred length
1!
with one hand and hold back
e
to MIN before turning on the vacuum cleaner!
and small uphol-
2%
on the
2@
11