Grinders Manual Handling - La Cimbali S39 TE Use And Installation

The operations described below are only
possible if the grinder control setting is NO.
Manually handle the grinders by pressing the PRG
CUSTOMER PROG.
KEY MENU
MANUAL MOVE
Press the PRG (29
the modifying panel:
Pos. M2
MOV. MANUALE MAC.
The displayed parameters are:
- M1
- M2 (grinder 2, upper).
Using the keys "+" (30) and "-"
on the grinder which requires modifying and press the
PRG (29) key. The display shows an additional
Pos. Pos. M2 26 M2
MOV. MANUALE MAC. MOV. MANUALE MAC.

20. Grinders manual handling

(29)
+
26 26
(31) place the cursor
next
26 26 26
Use the "+" (30) key to open the grinders (values 27, 28,
-" (31) key to close them (values 25,
24, 23, etc.):
Pos. Pos. M2 26 M2
MOV. MANUALE MAC. MOV. MANUALE MAC.
the value set in the technical programming menu.
Example
technical programming
Position M1 25
Position M2 30
Press the PRG (29) key to start moving the grinders.
The procedure ends when the 2 grinder reference values
Pos. M2
MOV. MANUALE MAC.
26 26 27
+ 5 of
customer programming
Position M1 20÷30
Position M2 25÷35
27 27