Table of Contents
Advertisement
5.
Type Yes to accept the agreement, and then press Enter.
6.
Enter a new CLI admin password to change the default password and then press Enter.
NOTE: The password must be at least eight characters long.
7.
Reenter the new password and then press Enter.
Juniper Networks Advanced Threat Prevention window appears. See
NOTE: By default, the JATP400 is installed as an All-In-One appliance.
Figure 14: Juniper Networks Advanced Threat Prevention Window
8.
Type Yes if you want to change the appliance form factor.
NOTE: If you type No, then:
a. Type Yes to confirm that you do not want to change the appliance form factor.
b. Proceed to Step
9.
Enter a number from 1-4 to choose your desired form factor. For example, enter 2 to change the
All-In-One to Traffic Collector form factor.
10. Type Yes to reconfirm to change the current form factor of the appliance.
Services are restarted and a successful confirmation message displays about the change of the form
factor.
11. Type Yes to configure the system by using the configuration wizard.
"11" on page
40.
Figure 14 on page
40.
40
Advertisement
Table of Contents
