Juniper JATP400 Hardware Manual page 19

Table 5: JATP400 Back Panel Components
Callout
12
13
14
15
16
Figure 4 on page 12 shows the back panel 10-Gigabit Ethernet port LEDs of the JATP400 appliance.
Figure 4: JATP400 10-Gigabit Ethernet Port LEDs
(Continued)
Components
10-Gigabit Ethernet SFP+ port
VGA port
USB port
USB port
COM port
Description
eth1. By default, this port is a 10-
Gigabit Ethernet fiber monitoring
port.
NOTE: You can change this port to 1-
Gigabit Ethernet copper port for
traffic monitoring through the
following command:
# set traffic-monitoring-ifc 1gb_ifc
After you reboot the appliance, the
eth4 interface becomes the eth1
interface and this port becomes eth4.
One VGA port. Use this connection
for VGA display.
Port 8 of USB 3.0.
Port 2 of USB 2.0.
One DB-9 COM port.
NOTE: This port is not supported.
12