Table of Contents
Advertisement
i.
Pull the inner rail out of the outer rail until it is fully extended as illustrated. Press the
locking tab down to release the inner rail, as shown in
has a locking tab that secures the chassis when completely extended from the rack.
ii.
Place the inner rails against the sides of the chassis, aligning the chassis hooks with the
holes in the inner rails, as shown in
iii.
Slide the inner rail toward the front of the chassis until the inner rail clicks into the locked
position.
iv.
Secure the inner rails to the chassis with the screws provided.
Figure 7: Installing the Inner Rails
NOTE: Each inner rail of the JATP400 appliance has a locking tab. The locking tabs secure
the chassis when either it is installed or completely extended from the rack.
b. Install the outer rails:
i.
Press the locking tabs upward at the rear of the middle rails, and slide the middle rails into
the outer rails.
Figure 6 on page
Figure 7 on page
30.
29. Each inner rail
30
Advertisement
Table of Contents
