Advertisement
umbing of the Waste Pipe
Wireless System Registration
Important Information
Please read the following information before setting up a wireless connection between the Whale Instant
®
Match
wireless transformer and Mira
• The electrical wiring must conform to EU wiring regulations BS7671:2008 Part 7 (17th Edition).
• This Whale Instant Match
wireless technology enabled Mira Advance Flex Extra Shower (J09N).
®
• Bluetooth
wireless technology enabled transformers can be easily identified by the blue test button.
• Wireless enabled transformers can be easily identified by the yellow test button.
• Locating the transformer outside of a 5 metre radius may cause a communication breakdown between
the transformer and shower, resulting in intermittent or complete failure to operate.
• Be aware that in very rare situations, dense building material, metallic objects such as steel baths and
foil lined plaster board, or electronic devices may interfere with the wireless signal and result in
intermittent failure. In this situation you should relocate the transformer closer to the shower.
• A hardwired connection should be established if a wireless connection cannot be made between the
shower and transformer.
• If any components or cords are damaged, it must be replaced by a qualified person to avoid a hazard.
Set Up
1. Shower settings
• Before beginning the registration process, please move the
jumper to the "wireless" position inside the Mira
Flex Extra wireless shower as per the diagram shown.
• At this stage please ensure that your transformer is set to be
used with wireless: the flow sensor setting must be set to 7 for
"wireless" and the pipe inlet diameter must be set to 1 for 15mm.
®
Advance Flex Extra Wireless (J97P)
®
Wireless transformer cannot be connected wirelessly to the Bluetooth
®
Advance
WARNING
Please set jumper on the
rear of the front cover
to "Wireless" position
®
WIRELESS
DRAIN PUMP
HARDWIRED
ON
ECO
OFF
SIGNAL
Advertisement
