Troubleshooting Guide - Heinner HMF-16WH Instruction Manual

www.heinner.com
VIII. TROUBLESHOOTING GUIDE
Questions Answers
1. Why is not the fan a.
operating lacking electricity or fuses may
have gone off.
b.
2. Vibrating Obviously. a.
installed tightly.
b.
c.
d.
3. The mist projector a.
is working properly material may have been added.
but there is not mist b.
spray. cracked or the flume is full of
water.
4. Why doesn't the a. Bobber doesn't float
mist projector work?
5. Why is there no a. Power cord is not connected
indicator light on, no properly and electric power is
mist and no wind? off
6. Why is there no a.
mist even though the b.
indicator light is on c.
and has wind? pressed out.
7. Why is there a a.
peculiar smell of mist? after some time.
b.
8. Other unusual a.
problems feeling a smell of burn.
b.
electric or the fan insulation is
damaged.
c.
damaged.
The plug inserted may be
PCB is damaged.
The rear guard is not
The blade can is loosened.
The blade is damaged.
the blade is imbalance.
Perfume or chemical
Water tank is broken or
No water in tank.
Water switch is off.
Water level bobber is not
Peculiar mist will disappear
Water tank is dirty.
Motor gave out smoke or
Metal parts exposed with
The rear cover of motor is
100W, 50Hz, 220-240V
Solutions
a. Make sure the plug works and check your
fuses.
b. Change the same type of PCB
a. Install the rear guard tightly.
b. Tighten the blade cap.
c. Change a new fan blade.
d. Turn the fan blade
installation again.
a. Clean the water tank, atomizing cup and
flume.
b. Put out the water from flume, change a
new water tank.
a. Pull out the bobber and let it float out.
a. Ensure that the power cord plug is fully
inserted into the electrical outlet and turn on
the electric power.
a. Add water.
b. Turn on the water switch.
c. Press out the bobber.
a. Take out the tank, and out it to a ventilated
add dry place.
b. Change fresh water.
a.b.c. Stop using and send your appliance to
technical service for maintenance
180°and then
7