Team Blacksheep TBS FUSION Manual page 25

VTX sync setup (Follow/ Lead/ Auto)
VTx sync allows you to sync the channel of the Fusion and your video transmitter over the Crossfire/
Tracer. To get it up and running, connect your Fusion to the Crossfire Tx WiFi AP. Depending on the sync
type there are different options for the wiring available.
Note: if your VTX is connected by CRSF to the Crossfire/ Tracer RX it can take up to 20 seconds for the new
channel to be sent to the VTX
Follow
With Follow the Fusion will follow the VTx change. You can connect your VTx straight to the Crossfire/
Tracer by CRSF or SmartAudio or with an FC in between when you use a LUA script on the remote. If you
own a Unify Evo which is connected by CRSF to the Crossfire/ Tracer transmitter you can change the
channel by the build-in OSD menu and the Fusion will follow it as well.
Lead and Lead Auto
Lead works when a VTx is connected straight to the Crossfire/ Tracer receiver by CRSF or SmartAudio.
25